|
Two
powerful, cost effective, shears which have the ability to
accurately cut PCB laminates, plastics, polymer plates up to
2.00mm thick and aluminium up to 1.5mm.
An important feature of these shears is safety. Free access to the
cutting area is prevented by heavy Perspex shielding extending
along both sides of the blade. A safety latch is fitted to the
pivot to prevent operation without it first being released. For
positional accuracy the cutting bed is fitted with a rule which is
recessed to assist in securing the PCB or sheeting whilst cutting
is in progress.
The 8" Cutter is extremely compact with an overall height of only
575mm and a footprint of 335 X 140mm. It has a cutting bed of
110mm wide from the blade although wider material can be cut.
The larger 12" Cutter will cut materials up to has a height of
670mm and a footprint of 440 x 245mm. It has a larger cutting bed
225mm wide from the blade although once again wider material can
be cut.
18"
and 25" Shears
Two
bench top shears suitable for cutting printed circuit board
laminates, thin metal sheet and aluminium (1.5/2.0mm) or plastic
labels / front panel materials. On lowering the operating handle,
a spring loaded clamp is activated which holds the material
securely during cutting, thus enabling cuts to be made with a
mini-mum of effort.
These shears are composed of an epoxy powder coated cast aluminium
frame fitted with hardened and ground steel blades. The 18" Model
has a clear acrylic front safety guard to protect the operator,
whilst at the same time making it possible to see the blades so
that the material to be cut can be aligned accurately.
Both , the 18" Cutter and the 25" Cutter have imperial and metric
edge scales and fully adjustable front and back stops for batch
work.
Corner Rounder
An
inexpensive invaluable tool to meet the demand for a quick corner
rounding facility for plastic/metal labels and front panels.
The table is effectively split into two halves, each containing 90
degree stops, in the angle of each is a hardened radius of either
6mm or 4mm. The punch has been ground to simultaneously marry both
of these rounds when driven down by the cam actioned handle.
The material to be rounded is slid from the left or right hand
side positively into the stops, to leave an overhang which is
sheared through by the punch to leave a clean
corner of
either
6mm or
4mm radius.
It
should be noted that material originally cut out of square will
result in an unbalanced round being removed. The table support
column is mounted on a 5" X 5" steel plate with screw holes for
bench fixing, although this will probably be unnecessary for most
users. Overall height with handle upright 8" (205mm) and weight
1.2Kg.
|
